Error Code E FS
Freezer sensor error — short-circuit or disconnection of freezer sensor
Moderate
Address soon - your appliance may not work properly
Also displayed as: E FS
How to Fix
- 1
Check CON8 Pin 22 ~ Pin 21 for short (0 Ω) or open (infinite) resistance. Short = replace sensor; open = proceed to step 2.
- 2
Check that the connector between Main PCB and freezer sensor is fully seated. Reconnect or repair any loose/damaged connector.
- 3
With connector properly seated, measure sensor resistance at Pin 22 ~ Pin 21 and compare against temperature/resistance table (-22°F=40kΩ, -13°F=30kΩ, -4°F=23kΩ, 5°F=17kΩ, 14°F=13kΩ, 23°F=10kΩ, 32°F=8kΩ).
- 4
If resistance is within normal range at the current ambient temperature, the system is operating correctly — explain to customer.
- 5
If resistance is abnormal but connector and harness are intact, replace the freezer sensor.
- 6
If replacing the sensor does not resolve the error, replace the Main PCB.
This Error Applies To
LG LRFGC2706S Series Refrigerators
Related Error Codes
Humidity sensor error — short-circuit or disconnection of humidity sensor
Freezer icemaker sensor error — short-circuit or disconnection of ice maker sensor
Freezer ice maker kit defect — malfunction of ice maker motor
Defrost sensor error — short-circuit or disconnection of freezer defrost sensor
Defrost heater error — defrost sensor did not reach 40°F (5°C) within 80 minutes after defrost start
Freezer BLDC fan motor error — no feedback signal from fan motor for more than 65 seconds
Refrigerator sensor error — short-circuit or disconnection of refrigerator sensor
Condenser (machine room) BLDC fan motor error — no feedback signal for more than 65 seconds